SuperCID your ppc-6850 and writing it's ESN. ...

SuperCID your ppc-6850 and writing it's ESN.

1. Boot holding power button and camera button to enter bootloader
2. start up mtty, and connect via usb
3. run command "rtask a"
4. run command "echo_on"
5. run command "writeCID 00000000" (you may want to run the next command readCID first to get the existing one!)
6. run command "readCID"
7. verify the new CID in indeed set!
9. run command rtask c
10. while in mtty it may not echo what u type but still continue and follow the Exact Process

Now Unlocking and Porting Method

1. Run GetSPC program from your Mobile and get the SPC of your Phone, Remember put ESN in Capital Letters and write down the SPC this will be usefull in CDMA Workshop
2. dial ##diag# and put phone in Diagnostic Mode or else just run DMRouter.exe from \windows folder of PPC and then Connect the Phone to miniUSB
3. Phone will ask for Diagnostic Modem Driver Just Point to the Attached Driver Directory if any time it ask for missing file point it to C:\Windows\System32 or C:\Windows\System32\Drivers
4. Start CDMA Workshop 2.7 Cracked and Connect the Desired Port if the HTC Diagnostic Port is not in Range Just Reassigns any Port in Range and Connect the phone
5. Send the SPC u got it from GetSPC.
6. Write the new E*N using nv_Write Method found in CDMA_Workshop (Nokia 6275 can be usefull to get all E*N min mdn of RUIM to set it on 6850) (Nokia 6275 *3001#12345# for reading RUIM ESN and MIN MDN)
7. MIN / MDN / SID / NID / PRL shoud be loaded using QPST 2.7 Build 263
8. Then there you have your voice and "should" be able to use 1x data as well if not, then go into **778* and change your Security and M.IP Default Profile settings to the correct usernames ( i believe telus uses ##########@rim.telus.com )
9. go into **778 and go to the Security tab and use the phone CTL + C to copy the passwords onto a word file. Do the same for the M.IP Default Profile, HA Shared Secret and AAA Shared Secret. Once you have all that copied onto a word document, bluetooth it over to the 6850 and paste it into the **778* respective settings. Also, change the other settings on the 6850, for example the Primary and secondary HA settings, MN HA & AAA SPI values. To be safe is to make the settings exact as the 6700 and you will be able to have data on your 6800 from sprint on your verizon plan.

Attached is the kit Containing TATA and Reliance PRL, CDMA Settings, Diagnostic Modem Driver, GetSPC to read SPC from Phone, mtty.exe, Manual

You still require CDMAWorkshop 2.7 Cracked and QPST 2.7 263 if CDMA Workshop could not load PRL
(For Indian Users) Set the Phone into NV_only mode in Security or else Writting MIN will get failed

If mtty dont connect Disable USB Connection in activeSync / in in mtty it says inValid Command you have to again Boot in Boot Loader mode and start again

say thanks to shadomite first and then only thank me !!